Installing the Ice Auger Bit

WARNING: The auger bit is very sharp. To prevent personal injury, exercise extreme caution when cleaning, installing, or removing the auger bit. Always wear protective gloves when performing maintenance on the auger bit.

Steps to Install the Ice Auger Bit:

1. Loosen and remove the locking screw from the ice auger bit.

2. Mount the upper end of the auger bit onto the drive shaft of the power head (Fig. B1).

3. Align the connection holes on the auger bit and drive shaft.

4. Use the locking screw to secure the auger bit to the drive shaft. Use the supplied 6 mm Allen key to tighten the locking screw securely (Fig. B2).

Components:

NOTICE:

Ensure the locking screw is inserted in the connection holes from the flat side of the auger bit hole.

Possible cause: Loose auger bit.