Skip to ContentHere, you'll find support for your Multi-Tool.
Multi-tTol
How to assemble the power head?
⚠ WARNING:
If any parts are damaged or missing, do not operate this product until the parts are replaced.
Use of this product with damaged or missing parts could result in serious personal injury.Always remove the battery pack from the product when assembling parts, making adjustments, cleaning, or when the product is not in use.
WARNING:
Read and understand the entire Operator’s Manual for each optional attachment used on this power head.
Failure to follow instructions could result in electric shock, fire, or serious personal injury.The 56V power head PH1420E is designed only for use with EGO attachment models specified in this manual.
Unauthorized attachments may cause serious injury or property damage.
⚠ WARNING:
Never install, remove, or adjust any attachment while the power head is running or with the battery installed.
Failure to stop the motor and remove the battery can cause serious personal injury.
NEVER OPERATE THE POWER HEAD WITHOUT AN ATTACHMENT.
The attachment connects to the power head via a coupler device.
Stop the motor and remove the battery pack.
Loosen the wing knob.
Remove the end cap from the attachment. Align the arrow on the attachment shaft with the arrow on the coupler, then push the shaft into the coupler until you hear a clear "click" sound, indicating it is locked in place (Fig. B).
Fig. B - Parts Description
| Part Number | Description |
|---|---|
| B-1 | Attachment Shaft |
| B-2 | Arrow on the Attachment Shaft |
| B-3 | Wing Knob |
| B-4 | Arrow on the Coupler |
| B-5 | Shaft-Release Button |
| B-6 | Power-head Shaft |
Pull the shaft to verify it is securely locked into the coupler.
If not, rotate the shaft side to side until it snaps into place.Tighten the wing knob securely.
WARNING:
Ensure the wing knob is fully tightened before operating the equipment.
Check periodically during use to prevent serious personal injury.
Removing the Attachment from the Power Head
Stop the motor and remove the battery pack.
Loosen the wing knob.
Press the shaft-release button and, while holding it down, pull or twist the attachment shaft out of the coupler.
Mounting and Adjusting the Quick-Adjust Front Handle
1. Stop the motor and remove the battery pack (if installed).
2. Loosen the wing nut to separate the front handle (Fig. C).
Fig. C - Parts Description
| Part Number | Description |
|---|---|
| C-1 | Lock Pole |
| C-2 | Clamping Block |
| C-3 | Quick-Adjust Front Handle |
| C-4 | Wing Nut |
3. Push the front handle onto the shaft within the mounting range between the threshold ring and the coupler (Fig. D).
4. Insert the clamping block into the handle slot (Fig. E).
5. Mount the lock pole and pre-tighten it with the wing nut.
Ensure the front handle is positioned upwards and points toward the top of the rear handle (Fig. F).
6. Adjust the front handle between the threshold ring and the coupler to ensure the front arm is straight while operating.
Verify that the front handle is within the mounting range (Fig. G).
7. Lock the lever of the lock pole (Fig. H).
WARNING:
Never use the tool without the front handle securely attached.