Skip to ContentHere, you'll find support for your Robot Mower.
Robot Mowers
How to install the Boundary Wire
CAUTION: Do not put excess wire in a coil. The coil causes interference with the product.
Was this helpful?
1
Read and understand the instructions about the charging station
Refer to 3.1 To examine where to put the charging station.
2
Put the charging station in the selected area
3
Put the boundary wire around all of the work area
Start and complete the installation behind the charging station. Put the front wire into the guide slot on the bottom of the station base. Pass both ends of the boundary wire up through the opening in the back of the charging station.
4
Open the connector and put the boundary wire in the connector (Fig. P1)
5
Close the connector with a pair of pliers (Fig. P2)
6
Open the cover on the charging station by pressing the release button (Fig. P3)
7
Push the front connector onto the metal pin on the charging station with the mark “F”
Push the back connector onto the metal pin on the charging station with the mark “B” (Fig. P4).
NOTE: Remove excess cable with wire cutters.