Skip to ContentHere, you'll find support for your Robot Mower.
Robot Mowers
Solid RED
Try this solution
Make sure that the boundary wire is correctly installed in the charging station
4.1 To Install the Boundary Wire
CAUTION: Do not put excess wire in a coil. The coil causes interference with the product.
Steps to Install the Boundary Wire:
Read and understand the instructions about the charging station. Refer to 3.1 To examine where to put the charging station.
| C-1 | Front of charging station |
|---|---|
| C-2 | Back of charging station |
| C-3 | Left of charging station |
| C-4 | Right of charging station |
Keep at least 1.5 m free space in front of the charging station, 40 cm free space behind the charging station.
Keep at least 35 cm free space from the boundary.
Keep at least 1.5 m free space on the work area of the charging station (Fig. C).
NOTE: The RIGHT side of the charging station (C-4) as shown in Fig. C must be placed inside the cutting area.
Placement Tips:
Put the charging station near a power outlet.
Put the charging station on a level surface (Fig. D).
The charging station base must not be bent (Fig. D).
If the work area has two parts separated with a steep slope, we recommend placing the charging station in the lower section.
Put the charging station in an area with protection from the sun.
2. Put the charging station in the selected area.
3. Put the boundary wire around all of the work area. Start and complete the installation behind the charging station. Put the front wire into the guide slot on the bottom of the station base. Pass both ends of the boundary wire up through the opening in the back of the charging station.
4. Open the connector and put the boundary wire in the connector (Fig. P1).
5. Close the connector with a pair of pliers (Fig. P2).
6. Open the cover on the charging station by pressing the release button (Fig. P3).
7. Push the front connector onto the metal pin on the charging station with the mark “F”. Push the back connector onto the metal pin on the charging station with the mark “B” (Fig. P4).
NOTE: Remove excess cable with wire cutters.
Possible cause: The product is not charging. The boundary wire is not connected to the charging station.
On this page