LIMBING AND PRUNING

This pole saw is designed for trimming small branches and limbs up to 20 cm (for tool with 25 cm guide bar) or 25 cm (for tool with 30 cm guide bar) in diameter. For best results, observe the following precautions:

1. Plan the cut carefully. Be aware of the direction in which the branch will fall.

⚠️ WARNING: Branches may fall in unexpected directions. Do not stand directly under the branch being cut.

2. The most typical cutting application is to position the unit at an angle of 60° or less, depending on the specific situation, as shown in Fig. T. As the angle of the pole saw shaft to the ground increases, the difficulty of making the first cut (from the underside of the limb) increases.

3. Remove long branches in several stages.

4. Cut lower branches first to allow the top branches more room to fall.

5. Work slowly, keeping both hands on the saw with a firm grip. Maintain secure footing and balance.

6. Keep the tree between you and the chain while limbing. Cut from the side of the tree opposite the branch you are cutting.

7. Do not cut from a ladder; this is extremely dangerous. Leave such operations for professionals.

8. Do not make the flush cut next to the main limb or trunk until you have cut off much of the limb to reduce the weight. Following proper cutting procedures will prevent stripping the bark from the main member.

9. Do not use the pole saw for felling or bucking.

10. To prevent electrocution, do not operate within 15 m of overhead electrical lines (Fig. T).

11. Keep bystanders at least 15 m away (Fig. T).

Was this helpful?